 Our stock 135i, with its distinctive...  Our stock 135i, with its distinctive front spoiler, waits for the new BMW Performance parts |  Our front spoiler was supplied...  Our front spoiler was supplied with all the parts to add headlight washers to your 1-Series. This could be very expensive if you don't need them, so make sure you order the right parts |  Remove four plastic Torx screws...  Remove four plastic Torx screws above the front grille and pull the rubber seal away from the headlights |
 There are eleven 8mm bolts...  There are eleven 8mm bolts under the spoiler to undo |  There are two bolts in each...  There are two bolts in each wheel well to remove |  Gently lift the headlamp washer...  Gently lift the headlamp washer cover, then unhook the cover from the nozzle underneath - it's held on by two tabs |
 The front spoiler should then...  The front spoiler should then be free to remove from the car, note the rubber seal remains on the grille but must be transferred to the new bumper |  Unclip the kidney grilles...  Unclip the kidney grilles from behind the bumper by prising the tabs free |  Install the supplied ducts...  Install the supplied ducts into the new BMW Performance bumper with the supplied clips and two push-rivets |
 Front grille simply pushes...  Front grille simply pushes on from behind |  The grille side pieces were...  The grille side pieces were blank, allowing no air in and obstructing brake cooling. Turns out, they shouldn't be fitted on the 135i |  Our shorter, stock bumper...  Our shorter, stock bumper support and the supplied engine shield adapter. The latter is required for the 128i. We decided to remove the stock part from under the car and use the new one to give more support |
 To fit the new adapter, place...  To fit the new adapter, place threaded clips onto the plastic part and screw to the undersheild |  New BMW Performance spoiler...  New BMW Performance spoiler now fits using all the original fixing points |  Original grilles push in from...  Original grilles push in from the front, but we'll be swapping these for black BMW Performance grilles later |
 You'll need to fix the new...  You'll need to fix the new bumper with 12 screws underneath and two in each fender |  The new front spoiler looks...  The new front spoiler looks cleaner and more handsome than stock. It's also slightly longer | |