Exhaust
Techtonics Tuning stainless steel cat-back exhaust system that bolts to the stock downpipe. System comes in two pieces, with the rear section split into two Borla mufflers with chromed round tailpipes. This systems fits easily, sounds deeper but isn't loud and retails for $875.
 Locate the center clamp under...  Locate the center clamp under the middle of the car. Undo these two bolts to disconnect the system from the downpipes |  Then lube the four hanger...  Then lube the four hanger rubbers - two by the center muffler, one by each of the rear mufflers - and pop them off |  The exhaust then comes away...  The exhaust then comes away in one piece |
 Take the center section of...  Take the center section of the Techtonics system and slide it into the stock downpipe |  Using the original rubbers,...  Using the original rubbers, hang the new section in the middle |  Refit the original clamp and...  Refit the original clamp and connect the new section to the downpipes |
 The two rear sections slide...  The two rear sections slide into either side of the middle section. Use the lube provided to help you |  Then hang the rear mufflers...  Then hang the rear mufflers with the stock rubbers |  Finally, clamp the rear to...  Finally, clamp the rear to the middle section with the Techtonics clamps provided. All the Techtonics hangers are straight rods, so the rubbers could slide off, so use the washers and clips provided to stop them sliding off |
 Slotted brackets are welded...  Slotted brackets are welded to each of the rear sections. These allow you to set the distance between the rear tailpipes and ensure they sit evenly in the bumper cut-outs | | |